CPO 350 Cold Saw

  • Manual Double Self-Centering Vise Assures Burr-Free Cuts
  • Operator Controlled Trigger Switch
  • Miter Capabilities 135 degrees, 90 degrees Left and 45 degrees Right
  • Miter Locking Device Stops at 45 degrees Left, Straight 90 degrees, and 45 degrees Right
  • Capable of Slotting
  • Two Cutting Speeds
  • Double Reduction, Hardened and Ground Worm and Wheel Gear Box
  • Worm Wheel of Top Quality Bronze
  • 7 Gallon Coolant Tank with Pump
  • 30" Material Length Stop
  • One 12-1/2" Diameter (315 mm) HSS Blade
  • One Blade Wrench
  • One Gallon Concentrated Coolant
  • 230 or 460 Volt/3 Phase Electrics (must specify voltage)
  • Warranty: One Year Parts
  • Made in USA
CPO 350 Cold Saw
Spacer Image

Capacities and Specifications

Cutting Speeds Must Specify when Ordering
LT(Low Turn) designed for solid mild steel, solid stainless steel & thick wall pipe LT (Low Turn) 22 rpm 44 rpm Motor rate: 3 hp 3 hp
LT (Low Turn) variable speed drive 12 to 82 rpm Motor rate: 5 hp
HT(High Turn) designed for thin wall tube and non-ferrous material HT (High Turn) 44 rpm 88 rpm Motor rate: 3 hp
HT (High Turn) variable speed drive 24 to 208 rpm Motor rate: 5 hp
SS (Single Speed) designed for 220v 1 ph applications SS (Single Speed) 44 rpm Motor Rate: 3 hp
Factory Wired Specify 208 3 ph 230 3 ph 460 3 ph 575 volt 3 ph 60 hz
Maximum Diameter Blade 14" 350 mm
Arbor Bore 1-9/16" 40 mm
Pin Spacing 4/12/64
Width 21-7/8"
Depth 43-1/2"
Height not including handle 56-1/4"
Height from floor to vise 37-7/16"
TUBING Round Square Rectangle SOLID Round Square 90 Degree 4-7/8" 4-1/2" x 4-1/2" 5-1/2" x 4" 90 Degree 2" 2" x 2" 45 Degree 4-3/8" 4" x 4" 4" x 4" 45 Degree 1-3/4" 1-3/4" x 1-3/4"
Spacer Image
Spacer Image