CPO 350 PKPD Cold Saw

  • Semi-Automatic Cycle
  • Pneumatic Power Down Feed with Electric Controls
  • Separate Feed Control of both Feed Rate and Feed Pressure
  • Power Double Self-Centering Vise Assures Burr-Free Cuts
  • Emergency Stop Button
  • Miter Capabilities 135 degrees, 90 degrees Left and 45 degrees Right
  • Miter Locking Devise Stops at 45 degrees Left, Straight 90 degrees, and 45 degrees Right
  • Capable of Slotting
  • Two Cutting Speeds
  • Double Reduction, Hardened and Ground Worm and Wheel Gear Box
  • Worm Wheel of Top Quality Bronze
  • 7 Gallon Coolant Tank with Pump
  • 30" Material Length Stop
  • One 12-1/2" Diameter (315 mm) HSS Blade
  • One Blade Wrench
  • One Gallon Concentrated Coolant
  • 230 or 460 Volt /3 Phase Electrics (must specify voltage)
  • Warranty: One Year Parts
  • Made in USA
CPO 350 PKPD Cold Saw
Spacer Image

Capacities and Specifications

Cutting Speeds Must Specify when Ordering
LT(Low Turn) designed for solid mild steel, solid stainless steel & thick wall pipe LT (Low Turn)
22 rpm
44 rpm
Motor rate:
3 hp
LT (Low Turn)
variable speed
drive 12 to 82 rpm		 Motor rate:
5 hp
HT(High Turn) designed for thin wall tube and non-ferrous material HT (HighTurn)
44 rpm
88 rpm		 Motor rate:
3 hp
HT (High Turn)
variable speed
drive 24 to 208 rpm		 Motor rate:
5 hp
SS (Single Speed) designed for 220v 1ph applications SS (Single Speed)
44 rpm 		Motor Rate:
3 hp
Factory Wired Specify
208 3 ph
230 3 ph
460 3 ph
575 volt 3 ph 60 hz
Maximum Diameter Blade 14" 350 mm
Arbor Bore 1-9/16" 40 mm
Pin Spacing 4/12/64
Width 21-7/8"
Height not including handle 56-1/4"
Height from floor to vise 37-7/16"
Shipping Weight 675 lbs.
TUBING
Round
Square
Rectangle

SOLID
Round
Square 		90 Degree
4-7/8"
4-1/2" x 4-1/2"
5-1/2" x 4"

90 Degree
2"
2" x 2" 		45 Degree
4-3/8"
4" x 4"
4" x 4"

45 Degree
1-3/4"
1-3/4" x 1-3/4"
Spacer Image
Spacer Image