Custom Dies
For over half a century, Vogel has specialized in custom dies tailored to your special tube fabricating requirements. Dies shown on this page are just a few of the many types of custom dies Vogel offers. Because these dies are custom built, costs will vary with the application. See some typical examples for special Vogel single and multi-operation dies below.
Arbor Piercing Die
For Piercing a clean hole through 2.5" OD x 1/8" wall tubing. Tube is slide over arbor (mandrel) against end-stop. Hole is pierced through both walls, with slug ejected below lower die shoe. Sharpenable punch, replaceable arbor. Tube is pierced with no deformation to the tube OD.
Flatten, Radius Form & Pierce Die
To form 1" schedule 40 pipe to bottom wall and form up into radius x 5-1/2" long. A second station pierces a square hole and trims end square.
Centerline Flatten and Pierce Die
For 1" O.D. x 16 ga. stainless steel tubing. Creates end configuration, including trimming end square and piercing hole - in one press stroke.
End Forming Die
To form and seal one end of a 5/8" O.D. tube with gauging and air ejection in one stroke of the press.
Centerline Flatten, Form, Pierce, Coin and Cutoff Die
For 1/2" O.D. x 18 ga. tubing with automatic gauging and stop. Makes one complete part per press stroke.
Feed-Through Double Flatten, Radius Trim and Pierce Die
Performs all three operations in one press stroke. This feed through design means one end of two parts is made simultaneously. An hourglass shape slug is created when the two flattened ends are cut.
Throatless Slotting Die
For slotting round, square or rectangular tubing to unlimited depths. Multiple hits required, depending on desired depth of completed notch.
Multislot™ Multiple Slotting Die
This tool is designed to create multiple slots around the circumference of a tube in one stroke of a punch press, normally used when four or more slots are required and tube ID is sufficient to allow for required mechanism in tube ID. Note that our Arc-Twin tooling can put in two slots, 180° opposed, in tube ends.
